How to Arrange a Gallery Wall with the Metal Grid IV

Quick answer

To arrange a gallery wall with the Metal Grid IV, measure your wall space, lay out the twelve 16x20 metal prints in three columns, and install them without a hanging template using careful leveling and consistent spacing.

How to install the Metal Grid IV step by step

1. Step 1: Map your wall space: Measure the wall area where the gallery will go. The grid is 48 inches wide (four 16-inch prints per row) plus three gaps, and roughly 72 inches tall (three 20-inch prints plus two gaps). Mark the overall rectangle on the wall with painter's tape. Common mistake: skipping the tape outline leads to off-center placement.
2. Step 2: Choose your gap width: Decide on a consistent gap between prints — 2 to 3 inches works well for a modern look. Write this number down and use it for every spacing calculation. Common mistake: changing the gap mid-installation creates uneven rows.
3. Step 3: Mark the center of each print position: Starting from the top-left corner of your taped rectangle, measure and mark the center point for the first print. Use a level to draw a light pencil line across the top row. Repeat for each print in the row, then move down to the next row using the same gap. Common mistake: relying on eye alone instead of a level causes a tilted grid.
4. Step 4: Install the prints row by row: Hang the top row first, using a level to check each print as you go. Once the top row is secure, use it as a reference for the rows below. Measure down from the bottom of the top row plus your chosen gap to place the next row. Common mistake: hanging all prints at once makes it hard to correct alignment errors.
5. Step 5: Step back and adjust: After all twelve prints are up, stand back and check the overall alignment. Small shifts can be corrected by loosening the hanging hardware slightly and repositioning. Common mistake: skipping the final check leaves crooked prints that are harder to fix later.

Product facts

• Metal Grid IV: This gallery does not come with a hanging template. You'll need to measure and mark each print's position manually, so a detailed layout plan is critical to avoid uneven spacing.